In today’s blog, i’m going to talk about a job Lawrie and I recently undertook which you should hopefully see on an upcoming What’s Broken Now, which was the annoying task of changing an auxiliary belt on my 2011 4.4 TDV8 Range Rover. The requirement to change the belt came after Lawrie and I FINALLY managed to get my Range Rover back to full power, a problem I have been tackling and tracing down for the last 4 months to no avail. As you will eventually see in the video, the issue turned out to be a totally blocked DPF (Diesel Particulate Filter) which was fully restricting the flow of exhaust gasses out of the turbos, and therefore not allowing them to generate any more boost. This would always bring up a red “Restricted Performance” warning and put the car into limp mode. Of course after fixing the issue, and the car running at full power for the first time in many years, the belt which apparently was only about half the width it should have been, finally gave up and snapped, leaving me at the side of the road. It couldn’t have really snapped at a better time as I was only around thirty seconds round the corner from “The Boys’ where we were fixing it. After Nige came out with the Hilux and flat towed me back to their workshop, we could get the belt ordered and return the following day to install it.

Now installing a belt…you’d think this would be a simple task…right!? WRONG….Because Jaguar Land Rover like making things difficult for you to work on your own car (ask Dave), this 4.4 litre engine is totally shoehorned into the engine bay. To get to the belt, the airboxes and associated pipes had to be removed, as well as the coolant expansion tank and many coolant hoses. But dear reader…it gets better! Not only did these things have to be removed, but also the fan cowling which was held on with well over 10 bolts, and the viscous fan which as it turns out, you need special tools to remove. Just getting to the belt took us well over 4 hours, and that was without a break! Removing entire valve units just to access one poorly located bold behind it was boiling our blood more and more. Finally, nearly 5 hours into the job, we could untangle the snapped belt, as well as cut the fan belt off from in front of it, and get the new ones routed round the plethora of pulleys on the engine and begin the challenge of reconstructing everything.

We started the job at 11:15…we left the boys at 8:30 after tiding up. Neither of us could believe quite what a pain in the proverbial that job was, but without it, the car would still be tuck on the ramp, and at least I now know the job has been done, and the belt is a fresh one that should last a good while now too. Buy JLR products…right Dave!?